Submersible Solids Handling Sewage pumps are designed for typical raw sewage applications.

• DISCHARGE: 6” 125 lb, ANSI Flange, Horizontal

• LIQUID TEMPERATURE: 104°F

• MOTOR HOUSING, VOLUTE & SEAL PLATE: Cast Iron, Class 30

• IMPELLER: Single vane enclosed type with pump out vanes on back side, Dynamically balanced, ISO G6.3, Cast Iron, Class 30

• SHAFT & HARDWARE: Stainless steel

• PAINT: Air dry enamel

• SQUARE RINGS: Buna-N

• SEAL: Double mechanical, 1.875 inch, Oil Filled pressure equalized reservoir, Carbon/Ceramic/Buna-N inner seal, Silicon Carbide/Buna-N outer seal

• UPPER BEARING: Single row, ball, oil lubricated

• LOWER BEARING: Double row, ball, oil lubricated

• POWER CORD: 25 Ft. G type cord. Epoxy sealed housing with secondary Pressure grommet for sealing and strain relief

• SENSOR CORD: 25 Ft. 18/5, 0.476 inch O.D., SOW type

• MOTOR: Class F Insulation, Oil Filled

• THREE PHASE: 230/460 Volt. Dual Voltage. Requires overload protection to be included in control panel

• SEAL LEAK SENSOR: Normally open (N/C), 2 probe design. requires relay in control panel. (Included in listed panels)

• TEMPERATURE SENSOR: Normally closed (N/C), requires relay in control panel. (Included in listed panels)

• WARRANTY: 1 year